Spindle Enabled
Spindle Enabled
Just wondering if there is a trick to getting the spindle enabled to work. Mist and Flood work perfectly fine, and if there is an issue I can just attach a relay to one of them to turn the spindle on/off. When I try to turn it on via the console, using UGS, I get no feedback on the console and if I use a multimeter on the board I get no voltage. Any ideas? Very new to this. Thanks.
Re: Spindle Enabled
Well just figured it out. I didn't realize you had to include the spindle speed with the on/off toggle command. I.e. M3 S1000 just in case someone else comes along looking for help as well. Really love this shield.
Re: Spindle Enabled
I guess the only thing I cannot figure out is toggling the spindle override doesn't seem to have any effect, unlike toggling the mist and flood overrides which work just as I would expect. So if anyone does have some insight into this I would appreciate it. Thanks.
- EccentricWorkshop
- Admin
- Posts: 38
- Joined: Thu Jan 17, 2019 9:33 pm
- Location: Olympia, WA
- Contact:
Re: Spindle Enabled
I don't have any helpful information other than it may be a GRBL behavior or within UGS itself. I do my testing with Candle and the spindle toggle works as expected. It may very well be sending the speed along with the command though.
Overall, I haven't been too impressed with UGS when I use it for testing. That's really the only use it gets from me.
Overall, I haven't been too impressed with UGS when I use it for testing. That's really the only use it gets from me.