Page 2 of 2

Re: Arduino Mega lite shield and TB6600 clone axis

Posted: Thu May 21, 2020 8:54 pm
by Brewnix
https://openbuildspartstore.com/xyz-touch-probe-plus/

Hi just picked this ^ up from OpenBuilds. Do have a idea or have had a look at it for connecting to the MEGA lite board. This has 3 wires red, blue and black. Port on board has 2 connections.I am thinking RED wire goes to 5VDC to probe port and BLUE SIG wire go to second probe port on board and the GND wire goes to common GND on Arduino? Just thought I would ask first. Thanks.

Re: Arduino Mega lite shield and TB6600 clone axis

Posted: Thu May 21, 2020 10:00 pm
by EccentricWorkshop
The probe port on the Mega Lite has a GND and signal connection. The signal is marked with the dot (near the E in probe). Connect the black wire near the P, the blue wire near the E, and the red wire to 5V and it should work.

Re: Arduino Mega lite shield and TB6600 clone axis

Posted: Thu May 21, 2020 10:20 pm
by Brewnix
ok will wire it up and try it out.Thanks!

EDIT- Ya it work great!